What is needed to start a hot water boiler?
Release time:
2021-08-12
Hot water boilers are common heating equipment in our daily lives and are widely used in China, especially in northern regions. Only by strictly adhering to the relevant installation rules and measures during installation can better installation effects be achieved. Correct use of hot water boilers can avoid a series of unnecessary hazards, ensuring boiler operation safety and personnel safety.
Hot water boilers are common heating equipment in our daily lives. They are widely used in China, especially in northern regions. Only by strictly adhering to the relevant installation rules and measures during installation can better installation effects be achieved. Correct use of hot water boilers can avoid a series of unnecessary hazards to ensure boiler operation safety and personal safety.
Today, we will introduce three important precautions for using professional hot water boilers to help you better understand their use.
1. Pay attention to the water filling method
The water filling method is an important way to ensure the safe operation of the hot water boiler. Therefore, when filling water, it is necessary to close the return pipe inlet valve, then open the circulation pump to adjust the water pressure to the appropriate range before starting to inject clear water. After the system is filled with water, adjust the boiler water level to normal, which can ensure that the performance of the hot water boiler is fully utilized.
2. Check before ignition
Before igniting the hot water boiler, it is necessary to check each auxiliary equipment of the boiler, and pay special attention to whether the valve opening is reliable, so as to ensure that the internal water circulation of the boiler is smooth and avoid steam blockage leading to excessive pressure. If serious leakage is found in the closed valve during inspection, it should be repaired or replaced in time, and ignition should not be carried out rashly.
3. Pay attention to cleaning debris in the water tank
The water heated by the hot water boiler is tap water, which is relatively clean. However, some debris may settle in the water tank during long-term use. If too much debris accumulates, it may damage the water pump and block the valve. Before using a professional hot water boiler, it is necessary to check whether there is any sediment in the water tank and clean it up in time, so as to ensure better heating effect and avoid high temperature and high pressure inside the boiler, resulting in danger.
If valve blockage occurs during the use of a hot water boiler, it may cause a surge in internal pressure. During use, attention must be paid to the water filling method, inspection of internal sediment problems, and pre-ignition checks. Only by fully implementing these three points can the smooth exhaust gas discharge of the hot water boiler be ensured and the normal operation of the boiler be promoted.
Latest News
Copyright©2025 Kemeng Energy (Yangzhou) Co., Ltd. ALL Rights Reserved.
Address 1: No.6 Jingang Road, Economic Development Zone, Yangzhou City, Jiangsu Province Address 2: No.6 Longjian River Road, Xinji Town, Yizheng City, Jiangsu Province